Hi, I am currently working on building an InMoov robot. I am using a Ultimaker 2 to print the ABS parts. So far I have about 30% of the parts printed. I have been keeping the Ultimaker printing about 18 hours a day, and expect to have all the parts completed by the end of August. I hope to be able to put the Ezrobot controller to good use.
Looking forward to keeping you all updated on my progress.
Blaine
By bjmccoy50
Other robots from Synthiam community
Redzone's Inmoov With A Slight Modification
Animate an Inmoov robot with EZB4 scripting, expanding servo control with EZB3 compatibility and iterative learning and...
Jim's Ezbv4 Robot Lawn Mower
Remotely controlled electric mower with 12V motors and dual PivoTrim heads-safe, modular FRC-based chassis, sealed...
Robohappy's Adventurebot4wd
4-wheel drive robot upgrade using four CR servos with Y-splitter cables to preserve directional control; camera, sensors...
