westies
England
Asked
— Edited
Resolved by Toyhackrobotics!
Robot Only Turns One Way
Afternoon All. I am using Ultrasonic radar which scans and displays reds dots ok. Also 4 wire H bridge which operates in all directions ok. But when used together the Bot goes foreward and backward fine but only turns in one direction. All check boxes are ticked on the radar config screen. What am I missing? Any help would be appreciated folks!
Is your servo port set to N/A?
If your sensor isn't mounted onto a servo, then it needs to be set at N/A.
https://synthiam.com/Community/Questions/10161
https://www.generationrobots.com/blog/en/2017/03/ultrasound-sensor-high-quality-ultrasound-sensors-available-now/
That link sheds a lot of light on ultra sonic sensors.
Good info and some video links of robots navigating around.
Hope that helps.
Thanks to all for suggestions. I tried different sensors with better results so putting it down to suspect device.
Wow thanks so much!
NEWAGETOMY you are a credit to the forum and deserve the credit. Thread can be closed now. (Can't see where to close it)
@WESTIE's- Aw you have made my night after reading that, thanks very much westies.