What is the torque and is it the same on a standard continuous rotation servo also?
RCStartToFinish
USA
Asked
— Edited
1 Participant
DHT11 Temp & Humidity Sensor
— Read DHT11 temperature and humidity on Arduino (signal pin 4) using EZ-Genuino_DTH11_Uno firmware; exposes $Temp and $Humid variables.
Try it →
What is the torque and is it the same on a standard continuous rotation servo also?
The Futaba S3003 servo is standard, Stall Torque (4.8V): 44 oz / in. (3.2kg.cm) Stall Torque (6.0V): 56.8 oz / in. (4.1kg.cm). If continuous rotation has the same torque than the normal servo. Just take into account when using continuous rotation wheel if the wheel is bigger gains forward speed but lose torque.
thx