Hi,
Just installed the EZ-B v4/2 comm board and i can´t get it to connect. Used both modes. This is AP. I get these errors as shown the snaps. Could use some help. Thanks.
SSC-32 Servo Controller V2
— Bridge ARC to Lynxmotion SSC-32: maps V0-V31 to SSC-32 channels for reliable, high-performance serial control via USB, EZB/Arduino UART.
Try it →
Hi,
Just installed the EZ-B v4/2 comm board and i can´t get it to connect. Used both modes. This is AP. I get these errors as shown the snaps. Could use some help. Thanks.
Did you upgrade to the new comm board?
Does your ez-b play a startup chime when powered on?
Have you attempted a factory reset?
1- yes 2- yes 3- yes
Wait, i will check my av.
Have you disabled anti-virus software? This one gets me every time. Also, make sure you've connected your computer to the board first and disconnected from any other wifi.
Yep, confirmed. It was my av software (avast). Thank you DJ and Mac.