Wavefront icon Wavefront — Wavefront grid planner computes collision-free, deterministic paths from start to goal using known occupancy maps for indoor robots. Try it →

ARC Pro

Upgrade to ARC Pro

Stay at the forefront of robot programming innovation with ARC Pro, ensuring your robot is always equipped with the latest advancements.

Author Avatar
Netherlands
Twitter YouTube
#1  

You could measure the TX signal. If its logic high is 5V, the RX will most likely be 5V tolerant.

#2  

With no Connection the measured level at the Bluetooth module Tx and Rx pins is 5V, so I assume that means that EZ-B is OK with 5V pulses. However, I am interested in replacing the Bluetooth module with an RF module that outputs 3.3V on its Tx pin. EZ-B will probably be OK with that, but I'm not sure. The Rx input of the RF module is OK with 3-5V.

Author Avatar
PRO
Synthiam
LinkedIn Thingiverse Twitter YouTube GitHub
#3  

It'll take up to 5v. Any voltage greater than 0 is considered ON. So even 1 volt is enough:)

#4  

Thanks DJ, that's good info. Thanks to both of you for the quick response.