All Community Content

Ezb 4 And Pulse Out For A Chopper Drive

So Im wondering if the ezb4 will have a command for pulse output. I need 5vdc pulses to the tune of some 20,000 pulses. Less pulses , less travel. More pulses ,more travel. Im not concerned about resolution. Or would I need to write a script and loop the script the required amount of times for the required amount of travel. Will the EZB 4 put out...

Standalone App

I was wondering if it was possible to build a standalone android app with the ARC ?

Indoor Navigation (Dj)

Dear Dj, Can the ez-robot navigate inside the building, meaning can we use map navigation to enable the ez-robot to navigate independently, also can we give a wireless command to the ez-robot.

Has Anyone Modified Digital Servo For Continuous Rotation?

I am having a hard time modifying HS5245MG to work. Mechanically, i got all the stops removed. So when turning the servo by hand it is free to rotate continuously. The pot(potentiometer) is 5K across the outside leads(green and red), and the inner (yellow) goes from few ohms to 5k to either side depending on which end of the knob is at. If I remove...

Ez-B V4 Gets 2 Uart Ports

The most recent version of the EZ-B v4 firmware now includes 2 high speed UART ports instead of 1. The ports can work up to 3,750,000 bits/sec. The standard UART Expansion Port has 10,000 Byte Buffer. The new Port uses 2 Dx pins and has a 4,000 Byte Buffer. You're welcome

Music V2

where can i find this musik.and whats the name.thank you Click To Watch Video

Roli Battery

Would this battery work with the ezb v4 https://www.hobbyking.com/hobbyking/store/__10310__Turnigy_4500mAh_3S2P_30C_LiFePo4_Pack.html I can't seem to find the max input voltage.

Items Not Yet Listed In The Shop

At the risk of repetition I'd like to initiate my first thread to raise items that are not yet listed for sale in the Shop but already available on full robots and some body parts. I'd also like to mention some items in my wishlist. This could serve as a checklist for those managing the Store. - JD's eyes (as already discussed in other posts) -...

Comparability

Hi Djcaan from uk living in osaka japan can I ask is the ez-b v4 robot controller compatible with 2.4 ghz remote controls units I have a turnigy 9 channel transmitter and receiver if it is compatible I will by this ez-b v4 Any help is most welcomed and will be returned in kind if I can help anyone Regards

Question With Controlling And Driving 4 Independent Dc Motors

Hello, I'm using a JeenNode board and H-bridge L298 to drive 4 independent DC motors. The motors are connected to mecanum wheels. Also, I am using 4 pushbuttons to control the movement of my robot. I guess the problem is in my code which doesn't allow me to control the motors probably. When the all 4 pushbuttons are connected and one of them is...