Robot Building Questions

Ez-B Client Mode And Router Conflicts

My problem is when I connect EZ-B in client mode my wife's WiFi connection goes down. @thetechguru stated in thread: https://synthiam.com/Community/Questions/7722 post #5 that: Quote:Although connecting in Client Mode, where the EZ-B connects to your router is probably best, the issue you are probably having is an IP subnet conflict in the wired...

Emg Sensors

Has anyone tried using any emg sensors with the ez-b yet other than the myo armband if so could you please instruct me on how to wire,program, etc. I havent been able to find anything on this other than the myo armband which I have working the myo is just limited on the gestures it can perform. Thanks in advance

Is The Ez-B Right For Me?

Hello everyone! Neogirl101 here! The reason that I joined this forum is because I see the Ez-robot platform as very promising- but there is a suggestion I would like to make. I've noticed that the EZ-b requires that it is always connected to the computer. I know that JD prefers it that way, but I personally would love to have an EZ-b that didn't...

Possible Bug Auto Position Movement

Project: advbot1.EZB The project is based on the Adventure Bot. Changes to help troubleshooting: 1) Added Http Custom Server 2) Added Http Server 3) Added Position Start Script $positioner_start_script=$hour*3600+$minute*60+$second Added Position Start Script $positioner_end_script=$hour*3600+$minute*60+$second Added Movement script:...

Ezb Microphone

From all the videos, I assumed the EZB had a built in microphone. Upon further inspection, it now seems I was mistaken? Does the voice commands then work through the PC mic only, and not the EZB? I am planning to use a small tablet bolted on to the bot to run the control software, so I can use that mic, but I am just making sure I am not barking up...

Ezb Failsafe?

Hi there. Is there a way to implement a failsafe on the EZB? Right now, if my EZB loses connection, everything stays in the state it was before the connection drop. It would be great if there is a way to implement a failsafe with default values to use in case of a connection break. If not a programmable failsafe, releasing all servos would do the...

Continous Servo Calibration. 90 Zero, Not Equal Up And Down

Hi guys. I have created a movement class for a two wheel bot setup (Like adventure bot). I copied the default values that ARC uses for a continuous servo movement panel. 180 108 1 I dropped the speed on each servo a little in ARC, and settled on a speed using. D1 150 108 30 D0 30 108 150 I then copied these values in my own project (SDK). I wrote...