-636459989693042832.jpg)
-636459989943960739.jpg)
-636459990485479714.jpg)
-636459980560649389.jpg)
-636459975718038038.jpg)
-636459969210457653.jpg)
-636459967995726605.jpg)
-636459970865108143.jpg)
-636465120384538626.jpg)
-636465113490053830.jpg)
-636475595612490698.jpg)
Here is the current look of this project, Super cool update, magpi magazine wants to feature this build with steps how it was done , !
By jstarne1
— Last update
Other robots from Synthiam community
Ezang's My New Update Arm Robot 11/14/2019
My new update to the Robot arm, added a 5th servo to the gripper - using auto-position - Ez builder software and Ezb4...
Lars1989's Omnibot 2020 - The Next Generation
Hello community, I bought an old Omnibot 2000 from ebay and want to give him a new life with the ez-robot kit: After I...
Ezang's Simple Bot Car Robot
No frills or thrills - no sensors or lights - I am Simple Bot, I hope you enjoy the simple life sometimes, its good for...
I’m running them separate , they connect through WiFi back to my network. I considered a router, but the way I am running them it is redundant. Each raspberry pi 3 records local to a 64 GB SD card and also stream through WiFi back to the network as well about 10 FPS. I was going to run one Pi and four cameras, but most the usb cams are night IR night enabled cameras and that would require I run them at 640x 480.
If I want to backup / save the files from a day I just connect from the pc and download them wirelessly and delete the old ones.
@maus666 I dunno man! My stuff is usually cool, I try to make things others would want to see as well!
Yeah man...its a pleasure! Keep it up!
Sensor disk gets the same plastidip gunmetal grey rubber coating. It is not as smooth , probably because of the humidity, the plastidip has seen sub freezing temps so maybe that plays a part. I soaked the inside of the compartment and also the wood bottom as well to protect the wood from moisture or transferring moisture from outside to inside.
Quick fiiment test on the main body
The rp3 cameras , weatherproof ultrasonic sensors, pyro / motion sensors , ez robot camera and IR illuminators have been mounted!
Take a look!
Each sensor is glued all the way around to keep water out.
Here is the electronics just sitting inside, but nothing is mounted yet as I need to first make a large hole all the cables will pass through.
Wow look impressive great watching transformation occur.
Pi was interesting approach for cameras but I think maybe look at the tech they use for drone racing next time. 5.8ghz VTX multi channel cameras and a receiver base station may have been another choice. Low cost, multichannel, High resolution, low powered and video is stored at base station.
Challenge you have with PI is if someone steals your bot they get the camera data and you have to keep unloading the memory cards. The problem with the VTX though is they are very easy to Jam.
Hey guy, thanks for the compliments. The Robot will have some anti theft measures. A alarm intended for a car will be installed as well as a Gps tracking unit with built in cellular modem that reports location on command or if the Robot leaves a geofence. As of right now they are set to record to the address card but eventually I will set it to stream only to a base that saves the data. I don’t have a base setup yet due to the budget , but it will be coming soon! Then all the data will be streamed to another location as well as stored locally and deleted locally every 4 days.