-636459989693042832.jpg)
-636459989943960739.jpg)
-636459990485479714.jpg)
-636459980560649389.jpg)
-636459975718038038.jpg)
-636459969210457653.jpg)
-636459967995726605.jpg)
-636459970865108143.jpg)
-636465120384538626.jpg)
-636465113490053830.jpg)
-636475595612490698.jpg)
Here is the current look of this project, Super cool update, magpi magazine wants to feature this build with steps how it was done , !
By jstarne1
— Last update
Other robots from Synthiam community
Jstarne1's Omnibot 2000 , Rad 2.0 Vacuum Bot
Modding two Omnibots (regular and 2000) with two EZ-B kits; rad base shelved for noise but may return if drivetrain...
Leversofpower's Omnibot 200 Mod Progress
Control Omnibot EZ-B lighting via Arduino Mega over serial with NeoPixel LED effects, programming progress and...
Ezang's Motion Detector
Control AM312 mini PIR motion sensor with ARC serial monitor and Arduino - DC2.7-12V, 3-5m range, 100 angle, low...
But he’s a bad guy
I started filling holes in the top of the aquarium I hacked up to make the round part of the Robot. I taped the front off and filled epoxy from the back.
I also started coating the gram and motor parts with the plastidip too. Not only does it color match the frame , but the idea is that plastidip will help protect metal parts from rust.
It depends on your perspective. He was a folk hero as well.
I sprayed a couple coats of the grey plastidip on the frame both top and bottom , 2 to 3 more to com ,but the look will be the same just thicker.
here is a mock up of the main peices in place without any screws.
So next I need to make this compartment usable. I cut out the right and left side of the motor controller mount out and removed the zip ties for the wiring. This has created a slightly deeper and wider space to work with. I believe I will hot glue in some fleece fabric and soak it in resin. If needed I will reinforce from the back side only to keep this area open. I am not worried about weight as this is designed to haul around a 300 pound payload.
Utilizing some red fleece as stretch clothe I got glued in a ideal shape to make the most of the compartment. Ideally I could have made it about a inch deeper but there would be a 3 inch wide high spot in the center which is the main support I cannot cut out. I did trim it about 3 inches on each side to give me more room to work with. You can compare to what I have as far as space in the Nom Nom robo mower and it is a big difference.
Ok fast forward a hour or so for hardening, I have a pretty uniform compartment that is mostly shielded from water spray. It does nothing for the lack of a seal around the topper though so I will need to do a little something about that.
I received the knobby 10 inch 4.10-4 tires from amazon. Amazing deal at 11 bucks each shipped. I went back to buy another couple and the price jumped to 36 whoa!
Of course I still will run a tube inside the tire.