Initial test of my InMoov robot running on the new EZBv4. I have 24 servos connected to one v4 and all are running OK.
Thanks for everyone's help to get it up and running.
By bhouston
— Last update
Discover more robots
Ezang's Video 2 Of My Metal Arm Gripper With An Arduino And...
Metal arm gripper with Arduino controlled via EZ-Builder (Synthiam) - Video 2 showing setup and control
Mickey666maus's Oled Animated Eyes For ARC Pro And ARC Free
Control ItsyBitsy M4 OLED eyes from Synthiam ARC via serial: flash firmware, send animation numbers over COM ports and...
Fisha's Wall-E Wall-E From Poland - Tribute To My Newborn...
DIY Wall-E robot with 12-14 servos, camera, ultrasonic sensor, MP3 trigger, amplifier, laser diode, VU meter mouth and...
Those modified HS-805BB are great motors for the arms and shoulders... @bhouston... Can your inmoov grasp and lift say a 500ml bottle of water?
On the inmoov site... the owner states that any printer with a print area of 12cm x12cmx12cm will work...
You can control those HS-805BBs without the external pots, but it is not going to give you precise control over the movements... Adding pots to the joints will provide feedback to the ezb as to the position of the particular joint... This is kind of important because without feedback you can easily over extend the joint stripping the gears or breaking the joint itself....
@bhouston. the part under the stomach. The v shape. is that what you made out of plywood for the stand.
@merne, correct.
@ Richard R, I have not picked up a bottle of water but I have seen other InMoov's do that and pour the water into a glass.
@bhouston... Thanks and great work... I have decided to take a stab at this... Just have to wait a week or two to get my printer....