-635260592782323404.jpg)
-635260594142255894.jpg)
I had the following hexapod. It had a dead controller.
After v3 upgrade. Also found a bad mini servo to and replaced.
learning actions and frames while, I wait for six to ship.
:)
j
update: robot chassis is 12 servo hexapod by dagu rs024, poor man's hexapod.
By jdebay
— Last update
Discover more robots
Jeremie's Fridgebot
Magnetic fridge-clinging robot using IoTiny, magnets and microservos for climbing, surveillance, whiteboard cleaning and...
R2D2's Robot Sphere (But Call Me Rs)
Robot draws a sphere with low-cost servos and a retractable arm housed in a reinforced 28cm PVC Christmas ball for...
Slim6072's My Wall-E
Wire BlinkM eyes, add sonar, mount camera on head and integrate MP3 Trigger-robot nearly complete and otherwise working...
@Jeremie,
thanks for the info.
I found the problem it is in Auto Position control. Working on setting up new Auto Position control and started new project.
j
@jdebay... Wasn't trying to make you feel dumb or wrong... If I did, I apologise... Possibly I am a bit too passionate about the v4 and sometimes I let it get my panties in a bunch.... Anyway, glad you worked it out...
@Jeremie... I appreciate you helping me out here....
@Richard R @Jeremie
I love the V4 too, AND LOVE EZ-ROBOT, but THE V4 is resetting... which makes mini-zip act funny. LOL
I made new project only Auto Position control only one frame and only one action. RESET
I removed barrel plug, RESET
I removed power SHELL part, RESET
Not sure what to do next?
J
Hi @jdebay
I understand you are using many servos on your mini-zip, what are you using as the battery supply?
Could it be a router problem? I had to buy a new router because my old one was causing constant disconnects (resets)....
jdbay uses eneloops rechargebles.
they are 1.2 volts,maybe its posseble when you count them all together, you get a little to low. eneloops are special batt whit very low drain.
@nomad18.08
no voltage regulator, no reset
ez-b v4 info controls input voltage 7.05 volts no reset
over max voltage for servos, interesting.
@Richard R
router is fine. no reset when testing food-botv4 or mini-zip with v3.
j
i count 6 eneloops is 7.2 volts.