Ultrasonic Collision Script icon Ultrasonic Collision Script — Ultrasonic sensor triggers custom script on object detection; configurable interval & min distance, with optional forward-only trigger for navigation. Try it →
Israel
Asked — Edited

Ez-Board - Some Questions

Skip to comments   Jump to end

At last I have received my Complete Robot Kit! Once again big thanks to you! I have some questions about my EZ-Board:

  1. What appointment of 6-pin connector on EZ-Board? It is designated as: (-MCLR * 3.3 * 5V * Gnd * Gnd * Vin)
  2. On my EZ-Board V3, Rev1 there is no R1 and C1. The diode D1 is soldered differently. It is updating?
  3. If the resistor and the condenser are necessary, what their face values?

Thanks.

Jump to end

ARC Pro

Upgrade to ARC Pro

With ARC Pro, your robot is not just a machine; it's your creative partner in the journey of technological exploration.

Author Avatar
Netherlands
Twitter YouTube
#1  

Hi! welcome to the EZ-robot community!

  1. I don't know what -MCLR is but 3.3 is 3.3v, 5v speaks for itself, gnd is Ground, otherwise known as minus and VIN is the input voltage for the voltage regulators.

  2. That's just normal, mine has that too.

  3. They are appearantly not.

Hope you have fun with your EZ-B :D

Author Avatar
Israel
#2  

Thanks for the help, Niek! The set has received only yesterday, therefore has had time to make only Version Update and to check up functioning of digital & analogue ports and interface to the WiFi camera. The most interesting still ahead! Regards.

Author Avatar
Netherlands
Twitter YouTube
#3  

Glad to help, have fun!:D

Login to post a comment