All Community Content

Wifi Limited

I have a Lenovo laptop and ever since I started using the WIFI with EZ-V4 I can connect but it is very slow, like graphs update at 1 second intervals and there is a ton of pauses. I then noticed that under the signal strength list for the WiFis the one for EZ-V4 board it says "LIMITED". I googled it and I see where people say that it is a...

Question About Adventurebot Sample Project

@DJ Sures I just added an AdventureBot to my collection, and I downloaded the sample app. Is there a particular reason you used the Auto Position Movement Panel instead of the Continuous Servo Movement Panel? It works fine, I am just trying to understand if there was some benefit, or was it just to show it can be done? Thanks Alan

Camera Disabled Message

This may be a duplicate post lost my Wi-Fi during first attempt. I just received my Developers Kit Yesterday. Working thru the tutorials and came to a stop on the camera. I received the following message; Camera Initialized: EZB://192.168.1.1 @ 320x240 EZ-B v4 Camera Error: System.IO.IOException: Unable to read data from the transport connection: A...

Auto Position And Ssc-32 Servo Release

I have touch on a similar subject in a previous post about using "Servo Release" using the virtual commands, to which a way of doing this has not been found. So I thought I would try the Auto Position control today, and used the virtual ports and set up some servos connected to an SSC-32U. On the digital ports in the Auto Position...

Ping Dj

Hey @DJ... Just a heads up... Check those bolts in inMoov's shoulders and elbows once in a while... Make sure they are good finger snug (maybe a little bit of wrench)... I say this because any slop (lateral movement) in the joint has a tendency to damage those plastic pots that read the joint rotation.... I killed 4 pots (in one shoulder) until I...