The Robot Program Episode 002: Building JD

Description

This lesson will demonstrate how to build the Revolution JD robot. Follow along with The Robot Program Episode 002: Building JD. At the end of this lesson, the reader will have learned how to download the EZ-Builder software, where to access the step-by-step building instructions, how to Clip’n’Play the EZ-Bit robot components, and how to secure the connections to the EZ-B Robot Controller for fully building JD.

View the video episode here: https://www.ez-robot.com/Tutorials/Lesson/61

Professor E's Overview

This lesson demonstrates how to build the Revolution JD robot.

The EZ-Builder software can be downloaded from www.ez-robot.com. Always start with a fully charged robot. Remember to disconnect the wires carefully.

Within the software, follow along with the step-by-step building instructions.

The robot components are called EZ-Bits. Each EZ-Bit connects to the EZ-B Robot Controller using male-to-female connections at the back of the robot. The port layout can be viewed in the Getting Started Guide. Be sure to match the wire colors to the corresponding port colors.

Adjust the cables so that they are coming out of the back of each EZ-Bit, which will make the connections easier to organize. Use Wire Wraps to clean up the cables into bundled sections, allowing the robot to have full range of motion.

User-inserted image


ARC Pro

Upgrade to ARC Pro

Stay at the forefront of robot programming innovation with ARC Pro, ensuring your robot is always equipped with the latest advancements.