Setting Servo speeds and Initialization Script Tutorial
There are a few controls found in EZ-Buider that have "Init" command tabs built in to the controls, as seen below...
HT16K33 8x8 Animator.
MPU9150 4 in 1 sensor.
These "Init" commands can be run straight from the control by clicking the "Init" tabs when needed, but they can also be run using the controls "Cheat Sheet" commands found in script editors...
Hopefully, the examples given in this tutorial will give you a good idea of what initialization scripts do, what they can be used for, and how to use them.
Tutorial created on 3rd October 2015