Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Other robots from Synthiam community
Mcsdaver's 3D Printed Ez Robot Bob
I forgot to click Robot Showcase so I am starting over here with Bob. Bob is my 3d printed EZ robot built with EZ-Bits,...
Gwen4156's The G-Bot (Gwen's B9 Robot Project) Gets His...
Took the G-Bot outside for the first time with him fully built up... Nerve racking to say the least... The bad new: He...
Ezang's Mr. Conehead Dancing, Take 1 - I Will Try More...
This is a test, hard to balance Mr. ConeHead dancing Take 2 soon :-)
I am ready Nomad for you to test exosphere now
EzAng
Nomad, what 3d printer are you using?
EzAng
its an creality ender-3 build plate 22 cmx22cmx25 high. self build pakket.low cost 170 euro
Hey guys, unfortunately at the moment ZOE is only using LOBOT LX-16A servos they cost less than 20$/20 on Amazon... Those LX16-A servos are very easy to use with ARC, I chose them because cable management is very easy with Serial Bus Servos!
But you could also wait, because next week, @DJSures will remodel the parts, so you can also use EZ-Robot HDD servos!
Mickey, want to try Exosphere with my robot?
EzAng
hey mikey
i just printed the head.i can adjust averything els.
Nomad, I going to get a 3d printer, thanks EzAng
dont forget to order a glas bed too.and a uhu stick