UBTECH Alpha Servos UBT-12HC icon UBTECH Alpha Servos UBT-12HC — Control UBTECH Alpha UBT-12HC smart servos via ARC using EZ-B v4/IoTiny UART, assign virtual ports, set baud, custom bits and position mapping. Try it →
USA
Asked — Edited

Haywire Servos When First Using Bv4113?

Skip to comments   Jump to end

I noticed an unusual reoccuring glitch while I played with the BV4113 last night. For some reason, the servos attached to D1 and D2 would go crazy the first time I did anything with the BV4113 (which was connected to D0). The problem would go away after I moved the D1 and D2 servos but reappear each time I rebooted the EZ-B but only during the first instance of moving the BV4113.

Anyone else experiencing this?


ARC Pro

Upgrade to ARC Pro

ARC Pro is more than a tool; it's a creative playground for robot enthusiasts, where you can turn your wildest ideas into reality.

Login to post a comment