kashyyyk

Powering H-Bridge And 12V Dc Motors And Feedback Pots

My next project is a BB-9. If anyone knows of it, I'm using the Joe Drive and 12v DC Planetary Motors with BTS7960 43A High Power Motor Driver H-Bridges. I'm using a 12V 20000mah battery for power. If I power the EZ-b with 12v, can I run the power from the digital port straight to the H-bridge, or should I power it from the power source? Thanks

Camera Movement With A Continuous Servo

In my R2 build I put the camera with a 180 servo that controls the up and down in the radar eye. I'm using a continuous spin servo to spin the dome and would like the camera to control that servo for side to side tracking, but in settings it appears that it has setup for a 180 degree servo. I tried the min/max with the continuous spin servo but it...

Micro Switch For Continuous Servo Limit Switch And Lights

I'm adding a periscope to my R2 and after reading a bunch of posts on limit switches, I want to know if I understand what I need to do. I've done no coding, just wrapping my mind about how to do it. I will need a switch at the top and bottom. I plan on using a micro switch on the top and bottom. From what I think I read is, I have the signal wire...

Uart Connecting To An Arduino

I'm very new to both the ez-b4 and Arduino and need basic help or advice. With my robot I want to be able to control LEDs through an Arduino. I have a Mega and with it I can add more LED functions to it as I learn. I've been reading a lot of posts on this and I took in so much info, I think I'm just dangerous and not knowledgeable. I want to start...

Can't Connect To Home Netgear Home Wifi

I can't get the Ezb to connect to my home WIFI. My computer doesn't have WIFI so I need it to connect in client mode. From my cell phone I connect to the Ezb, go to the IP address and select client mode. I typed in my SSID and password, It's on a sticker on my router and I type it in the same caps as on it and the ez says can't connect to network....