Here is the robot head video for 6/15/2021: hope you enjoy it.
In this video I break down all the components that went into him,
..
By EzAng
— Last update
Other robots from Synthiam community
Bhouston's A New Dof For Inmoov's Neck/Head
New InMoov neck mechanism adds an extra degree of freedom, improving head articulation; prototype needs fine-tuning.
Buratino's Basilio
Basilio 45cm 3D-printed walking robot with 26 DOF, external potentiometers for pose capture, seeking EZB/EZ Robot...
Jp15sil24's 3Wheelbot
Synthiam ARC-controlled 3-wheel AdventureBot: remote and internet control, camera tilt, ultrasonic wall-avoidance,...
hi ezang
using avery bits and parts to make something . you can print some eyballs .
eyeballs
Thanks for the link Nomad,
However, I am using lights, red LEDs instead of eyeballs, a small servo for mouth, a few servo city parts, Ezb4 controller with battery, some wire, washers, and screws, mask, ARC for programming etc...
EzAng, You are always busy building, I admire your drive. Hue is getting more expressive. The mouth movement adds a lot to it. He looks like he is Trekking in a Borg Cube. Thanks for sharing. Steve S
Thank Steve always for your comments
EzAng