cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Discover more robots
Wolfie's Well Its A . Start
Convert an RC snowcat into a robot chassis: test servos, wire an H-bridge to an EZ-B controller, and power up a working...
Tony1952's My Wall-E Powered By Ez-B V4
Control WallE with EzB V4 and EzBuilder: continuous rotation servos, tracks, WiFi, voice, face tracking, scripting and...
Ezang's My New Crane Robot Video Below
New crane robot built with Servo City parts, dual servo blocks for strength and a servo winch pulley; photos and video...
Watched the youtube-video - man, those rubber threads look good. do they handle the weight without running of the wheels? how did you manage to fix them on the plastic wheel? did you glue them or did you find a solution to make them interchangeable once plastics start to fade again ?
I just glued them on they can be.pulled off.if needed
i hate glue,some so very hard to remove,then to clean it and add glue again plus sometimes the item doesnt hold very well too,but i guess on wheels it might be the only way
Josh the ones you sent me. I stuck wire in them to hold them together and then sealed the gap with the left over tube you sent. Worked great.
That's super. IM making a set of red ones for a newbie in trade for a omnibot dome
Looking really good Josh!
Thanks Brett! It feels great to see this guy in one color for a change! I still will fill a few areas but it's getting there.