cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Other robots from Synthiam community
Mickey666maus's Cycloidal Reducer 40:1
This is a WIP of a cycloidal gearbox with a reduction ratio of 40:1. It is driven by a Tarot 4108 brushless motor, in...
Rural's My Experiment 626
The robot I am starting to build is scratch built think. My idea is its going to be a platform to expand and experiment...
Jeremie's Ravage The VHS Tape Robot
Here is my VHS tape robot named Ravage by @JustinRatliff Its named after the G1 Transformers Decepticon cougar robot...
Josh, you have made amazing progress considering the complexity of your build. I can't wait to see the pain on there!
Thanks Brett ! , ok not waisting any time this morning I cut.up pieces of.fiberglass matt and started glueing them in place. Using a brush I saturated the matt. I did this on Jarvis and junior. Junior appears to be done Jarvis needs some touchup on front and back panels.
Jarvis Jr.Oh im removing Jarvis name badge and making a decal later.
Ok here is the torso LCD screen , I will have a inch above and inch below , once I cut the hole I must fiberglass in and reinforce the tv recessed mount around all edges and the back as it will become structural at that point.
where did you get the monitor,might need one like it for another project
Ok my little brother is cutting away for the hole the tv will mount to. While he's doing that I'm checking out the junior base so it can be modified and cut to house the vacuum head. The vacuum is a inch wider tha. The omnibot base so this one is tricky for sure.
I marked everywhere I must cut to graft in the shark power head. The front dummy wheels and front.bumper area will be completely removed. Once removed I must scuff the power head with.60 grit and place the base on a level surface and epoxy it into place.
Test fit the tv in torso riser , edges must molded with filler because the front is curved.
My 16 yr old brother Alequa learning how to mod things , he's always wanted to take stuff apart but not had opportunities to be part of something real. So I'm turning.up the pressure and letting him do all the main cuts. Hopefully this will influence him to go to college instead of going in the army to be a mp (military police). I'm pro military but he's just like me and I wish.I had someone to.look up to , to see college these days is a must not an option.