Hello Guys my Self Mohanish From India and i'm also an Mechanical Engineer and working as a Designer. i would like to know that how to make robots? frankly speak i'm totally unaware about it. i was try searching on Google but cant find anything what i required. on Google i was find this site and its look like what i required
I need to know how robot works?
I need to know which parts are Required for making 4 wheel Drive Robot with operated with Laptop or remote control
I need to know what parts do what things.
i need to know from where i get that all parts.
i need to know how to assembled all that parts electrically and mechanically both
All of u r requested to shear your knowledge with me
here i'm attach 2 Photos which i was make in 3D
By mohanish
— Last update
Other robots from Synthiam community
Daedalus's Android Robot
Hi, My First Robot is Talos 185 cm. This robot will be constructed for control home and as personal transport goods...
Kab's Ogie The Bear In Action
www.facebook.com/kabartstudio/videos/882456251867419/ Finally finished making Ogie the talking bear with the EZ Robot...
Ezang's My New Robot - Spider Bot
If you missed my new robot, here it is again, enjoy and laugh:
yes i need it but let me start somthing first
i'll add camera latter on for sure
how much Motor Controllers i need to make 4WD robot or 6WD robot? one Motor Controller control all 4 or 6 motors or i need it individual? confused confused confused confused
and which one i use? any specific make or module number? confused
You only need one sabertooth 2 x 12 controller to control 4 or 6 motors just fine as long as you don't exceed 12 amps per channel (which I doubt you will).... Google the Sabertooth 2 x 12 to find our more info on it...
how to connect 6 DC motors to motor shield? confused confused confused confused
Did you google it? Ok, I will do it for you...Sabertooth 2 x 12 user Guide
Yes I google it but I can't understand one thing that 6 motors = 6 wires (+ & -) both there is only 5 motor arrangment Sabertooth2x12 then how I manage? Please send me schematic diagram for it if possible so
In short which wire where go?
There are two motor channels on the Sabertooth... You will wire (in parallel)... 3 motors on one channel and 3 motors on the other channel... same as the picture below, but with one more motor on each side... Very simple...
Ohh I c that mens 1 slot for 2 motors right?