Hello Guys my Self Mohanish From India and i'm also an Mechanical Engineer and working as a Designer. i would like to know that how to make robots? frankly speak i'm totally unaware about it. i was try searching on Google but cant find anything what i required. on Google i was find this site and its look like what i required
I need to know how robot works?
I need to know which parts are Required for making 4 wheel Drive Robot with operated with Laptop or remote control
I need to know what parts do what things.
i need to know from where i get that all parts.
i need to know how to assembled all that parts electrically and mechanically both
All of u r requested to shear your knowledge with me
here i'm attach 2 Photos which i was make in 3D
By mohanish
— Last update
Discover more robots
Leversofpower's Un2003a 28Byj48 Stepper Motor Project
Implement the UN2003A 28BYJ48 stepper controller for low-cost open-loop positioning; easy hardware setup; listed in...
Klaatu's 1 M Hexapod (Autonomous Insect)
Autonomous 1m hexapod with EZ-B V4-2, 18 servos, LiPo power and Synthiam Blockly control for garden navigation,...
Joseph4760's Project X-Men
Project X-Men: EZ-Robot custom builds, modified tank with IP camera and sensors, Brookstone Rover, RAD 2.0, Ghost Rider...
Yep, and in your case one "slot" (or Channel) for 3 motors...
yap Thanks @RIchard
Hay Guys i was changed my motors
Output shaft = 4mm dia. Voltage = 6V Speed = 133rpm No load current = 0.35 A Stall current = 5.5 A Stall torque = 8.8 Kg/cm Motor RPM = 10,000 +/- 5%.
Still i need to go with "sabertooth motor controller 2 x 12" ? confused confused confused
Yep, the 2 x 12 can handle 12amps per channel... and it has an over current protector... Meaning it will shut down and reset if the motors try and pull too many amps... Also, it is highly unlikely that you will stall all 3 motors on one of the channels all at once....
do i use Dual H Bridge DC Stepper Motor Drive Controller Board Module L298N for Arduino?
and is this possible the if u like to use one Dual H Bridge Motor Drive Controller for 2 motors and another one for other 2 DC motors? is that possible ?
As I mentioned before... You can use 1 sabertooth for 2, 4 or 6 motors or 1 H bridge per 2 motors... However a standard 2.5amp L298 H - Bridge won't be able to power your new motors....
ohh I C then i'll go for sabertooth i was ask that b'Coz it wont b available here in local market that's y
Hay @Richard i'm back with another Question
Question:- Do I Need Solder a ceramic capacitor across the terminals of all 4 motors? confused confused