Hi all
I have a made a new 2 DOF quad.
He is called Crabio 1.
I only have time to add a video about him for the time being.
I will post more pictures soon.
His walking pattern is abit noobish but i will fine tune him later:)
enjoy for the time being:)
By iskandershah
— Last update
Other robots from Synthiam community
Fredebec's Another Wall-E. But French ;)
EZ-Robot Wall-E build: LIPO-powered mobile bot with EZ-B camera, MP3-triggered speaker, continuous servos, LEDs, cooling...
R2D2's Robot Sphere (But Call Me Rs)
Robot draws a sphere with low-cost servos and a retractable arm housed in a reinforced 28cm PVC Christmas ball for...
Wolfie's Well Its A . Start
Convert an RC snowcat into a robot chassis: test servos, wire an H-bridge to an EZ-B controller, and power up a working...
Hahah
Wait for my next video.. i am sure it will be as entertaining:)
He can now run, lean, kick a ball and sits:)
This is a very exciting robot! Very good work
I know everyone would love to see your ARC Project File if you're willing to share your hard work
Cool robot! Good movements for such low DOF.
Hi guys!
as requested by DJ Sures, here is a overview about my ARCs.
And Crabio One Learns new tricks!
watch it!
Please comment:)
Man you did a great job!!!!!
Hahah Thank you DJ Sures !!!
As you can see on the last part of the video, Crabio Started losing power and falling to the ground.
Does that mean that the board has been over worked? any way to counter this? I am using a DC 12V bench power adapters..
Please advice.
The 12v bench power adapter from EZ-Robot? That should be good - but there are a lot of servos and the voltage regulator may be getting a tad too hot. It'll shut down when it gets too hot.
Amazing ! Good job !