Built out matching 1500 MAH NiMH packs (one per foot) also aux power from either battery back to run the EZB. Should run for a bit between charges.
Well on to building frames for actions.
By kleinjd
— Last update
Other robots from Synthiam community
Foamtastic's Working On A Baby Dragon.
ALL VIDEOS HAVE BEEN MOVED TO MY NEW YOUTUBE CHANNEL, https://www.youtube.com/channel/UC0rzTuN8JW_pY0RDhS7Q0BA when I...
Linux's Project Roll-X
I am glad to announce my next project after the omega project stage one is complete, introducing project Roll-X stage...
Kab's Ogie The Bear In Action
www.facebook.com/kabartstudio/videos/882456251867419/ Finally finished making Ogie the talking bear with the EZ Robot...
That is SWEEEEET
Thanks, this should be a lot of fun. Need to figure out a good support to keep him upright while I work on frames and adjust for his CG. He really needs to be supporting his weight to get the positioning right with so many DOF.
Nice, Please upload a video when he starts moving.
Very awesome! I'm really excited to see videos also!
The Auto Position control with movement is perfect. Take a look at the example robophilo project as a start
Well that was interesting, just set the speed down real slow, and started a nice smooth motion to stand on one leg. Fortunately I am running him off a bench power supply. Watched the current go to almost 2 amps, with all the weight on the left leg!
Looking at the servo spec, it says they will take up to 7.4v at 1.4 amps each at stall ! I am not sure I believe that spec. The original batteries were 6v, and he would run for about 15 mins on a 1000 mAH battery just walking. I am a bit nervous since Hitec does not make these servos any more, and they are hard to find if I toast one.
The knee took the weight but got more than a bit warm to the touch.
Am I just being paranoid?
Here is the servo spec if you are wondering.
Darn Knee servo went. stress
I can't tell from the pic but is there a fan on the ez-b?