cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Discover more robots
Lemon's Galapagos Mode- Scorpion Tail
Tortoise bot rebuilt with short legs and a scorpion tail, showcasing custom modifications and creative design.
Jeremie's Beastly The Drifting Robot
Beastly drifting robot with mecanum wheels for sliding & strafing, built with EZB hardware & controlled via...
Moviemaker's Well, It Is Obvious That I Did Not Sell My V3,...
Frankenstein scrap robot from Sunshine, Omni-Bot, RAD and electrical box, voice rec/gen works on desktop, sensors and...
thats great JOSH hope to see the guy working soon (omnibot) i see i made the 50th page long thread
I give it 3 weeks before he's moving , my painter will have it a week maybe more then I gotta install all the electronic guts again. , one thing I have not descided on.yet is if I.will leave the led holders stainless steel or paint them red at the same time. Hmmm
if you paint them is wont shine very well,stainless steel is like a mirror
This is what I was talking about...
Dremel Flex Shaft
yes thats the same one that comes with the kit
Ok I.see what you mean , I will leave all the holders stainless steel.
I am also cutting two holes for illuminators
here's the placement.
I could not tell. I have had mine for years.
I really cannot wait to see this guy all together.
Ok I started cutting on the second torso, I had the.idea of adding these.flashlights to.the lower torso.