Asked
— Edited

i know this is not ez robot but i though to ask to understand why they are not working.
i f you set sensors like in the videi separt they do works.
i know this is not ez robot but i though to ask to understand why they are not working.
i f you set sensors like in the videi separt they do works.
2) Is the ambient lighting good
3) Did you program it properly(assuming you need to)
4) Serves connected properly and working?
anything.when i check servo manager ,i see the ax-s1 responding well.
maybe a video would be good.
in the first video you all sensors works in the manager.
second video you see the real robot sees nothing.
You have your code >=40 and >=50 What happens if you change it to <=50 and <=40 instead?
the lower value the further away is the object.
the higher the value ,the chorter is the object.
50 is about 20 cm away from the sensor.
the program itself says the sensors are not good for precies distands.
also have alot influance whit chades&lights
but my exsperiance telling me,its not working at all on a robot.
as you see the above video,they work only separt.
reason more to choose EZ ROBOTS haha
due to that ax-s1 is connected like any servo.it dont have a port.
but am gonna check it for sure
under the number 40 or 50 you see jumpto left or right,that what he chould do.
its preprogrammed allreddy in the software.
normal is the comprehencive whit a cm-5.i use the cm-510.
the programmer from bioloid says it chould work.
but you bolt have good idea.cause i dont see the object behavior in motion (software).
it was the task closing was not correct.
Cheers
Richard