with the new batt wil i need to reset connection or calibrate? roli jd six
Asked
— Edited
2 Participants
Neopixel Blaster
— DIY NeoPixel Blaster for ARC - open-source controller for up to 8×80 LEDs (640), port‑0 onboard RGB, color control via ControlCommand
Try it →
No, connection information should be maintained without power while you wait for the new batteries, and servo calibration doesn't have anything to do with the power supply.
Alan
thank you alan
@nomad... swapping out batteries is the equivalent of turning JD off with his switch, both cut power to the robot.... All servo settings are saved on your computer, not the ezb...
sorry late replay rr
am i lucky then.