Asked
— Edited
A new lesson needs to be added Fine Tune Six's Servos - Six Hexapod
I looked at Fine Tune JDs Servos - JD Humanoid
and did it for my Six, he works much better in movement and so on.
j
There is no reason to fine tune Six's servos within the software. They merely need to be adjusted by following the Calibrate Lever Servos. The Calibrate Lever Servos is mentioned as a Prerequisite.
So I did it, and my six works better.
J
*confused* *confused* *confused* *confused*
Then after Rich it needed more.
I did the fine tuning.
J
The method is the same for all robots. I know the fine tuning is under JD in the Lessons but the same applies to Six and Roli (and any brackets purchased without robot). What I'm getting at is would the lesson may be better placed under EZ-Bit servo Calibration rather than JD Humanoid?
If you did the Lever servo Calibration then it's just a case of fine tuning. Lever servo Calibration may not get all servos to align with the brackets.