Welcome to Synthiam!

The easiest way to program the most powerful robots. Use technologies by leading industry experts. ARC is a free-to-use robot programming software that makes servo automation, computer vision, autonomous navigation, and artificial intelligence easy.

Get Started
Belgium
Asked — Edited

Ez Builder Freezes And Disconnects

i got latest version,and when i use a vertikel servo it freezes and disconect the ezb4
any idea ?


ARC Pro

Upgrade to ARC Pro

Get access to the latest features and updates with ARC Pro edition. You'll have everything that's needed to unleash your robot's potential!

United Kingdom
#1  
Is it any servo you use the vertical servo control on or just a specific one?

If just one servo, is the servo connected correctly? Does it move OK with script commands or other controls?

Are your batteries charged?
PRO
Belgium
#2  
its one servo connect to d4 and am using vertikel servo.
batt are ok
servo move to the right side and when i go to the left all freezes.
#3  
When in doubt... Do the 3 "R"s... Reboot, reinstall ARC and retry your project...
United Kingdom
#5  
Swap the servo on D4 for another servo. Try the control and see if that causes the same issue.
Put the servo which was on D4 on another port, change the control options to the new port and try the control and see if that causes the same issue.

If it doesn't cause an issue with a different servo on D4 but the servo which was on D4 causes an issue on another port then you have a faulty servo. Replace it for one which isn't faulty.
PRO
Belgium
#6  
rich

i did change the servo and same problem.

rr

i did the tree RRR no luck


rich i try another port
PRO
Belgium
#7  
i tested the batt and some are empty.
i asumed the whats in ARC is correct,i got there 7.79 volts
so that solved the problem

thank you bolt

ps i found the weather broadcast.
Login to post a comment