Progress on the lower and mid stomach!
Just getting the neo pixel ring running, hopefully will be installing soon! Not sure if I can shove an Aduino UNO in there, or if I am going to have to get a nano because of space.
By Tonzatonka
— Last update
Discover more robots
Kashyyyk's R2-Q5 Droid Build With Ez-B4
R2Q5 3Dprinted droid using EZB4: camera in dome, RGB LED magic panel, servos with buck converters, scripts for panels,...
DJ's Elastic Band Shooter
Elastic band shooter for hexapod in Synthiam ARC: servo uses a hexapod leg to raise/lower the body for vertical aiming....
David's 3D Printed Ez Robot Bob
Bob, a 3D-printed EZ robot built with EZ-Bits, 3D-printed parts and hot melt glue for DIY robotics and easy...
Thanks everyone!
Hey Perry, I have to admit that when I was choosing between MRL and Synthiam, I watched your videos which helped me to decide Synthiam was more than able to run this bot.
Thanks for sharing!
Hey Perry, is it difficult to control neopixel rings with ezb4?
great stuff, thanks for sharing
EzAng
It's always great to see another InMoov here. Check this tutorial out for getting a neopixel ring running with an EZBv4.
Saw a couple of questions for me. @DJ - Hands were always tough point for my inmoov. So fiddle and I think that the basic design is not there. Even Gael's bots seem to have messed up hands. I could get mine to work fine then once I rotated the wrist a couple of times slack would always occur in the tendons. I ended up having one normal hand and one with Flexible joints that Bob Houston designed. They both worked about the same. The rotating wrist really messes things up. Nallycat may have something here.
@TonzaTonka - The neopixel took some work but the community here squared it away and helped me get it working. It is pretty seamless now. Look for the tutorial on this site for it. Might be in my thread as well.
Hi Tonzatonka - what 3d printer do you use?
Hi EzAng, I use a Folgertech FT-5. What are you using?
Don't have one yet, deciding what to purchase