I have a quick question I hope someone can answer for me. I want to make cables for the USB/TTL to the EZB V4 camera port but I need to know type of connectors the camera port is? I think they are JST-PH 2mm connectors but I would like to make sure.
smiller29
USA
Asked
Resolved by DJ Sures!
1 Participant
EZB V4 Camera Port Connector Type?
Related Hardware (view all EZB hardware)
EZ-B V4
by EZ-Robot
EZ-B v4 with Synthiam ARCx controls servos, sensors, camera and audio over Wi-Fi or USB serial, no firmware needed.
Wi-Fi / USB
Servos
24
Camera
Audio
UART
3
I2C
ADC
8
Digital
24
Does it say in the data sheet? Here’s the link I googled for ya: https://www.ez-robot.com/learn-robotics-ezb-smart-robot-controller-and-iotiny-datasheet.html
Once again you are correct! I could of swore I checked that document when I downloaded them. I was right JSP-PH are the correct size.