Asked
— Edited
Servo was working fine. Shutdown JD. Then when restarted JD found a bad servo?
See pictures:
See red area:
J
stress stress stress stress
Read Digital
— Read TTL digital input from an ARC I/O port; real-time red/green status for low (0V) or high (+3.3/5V), selectable board/port and read interval.
Try it →
That slightly burnt plastic should be a sign that something was cooking (it wasnt marshmallows
)
I would suggest using the warranty section in the Contact Us page to get a new servo, since I'm sure it wasn't your fault.
It looks like the servos Driver chip overheated or the servo was shorted out.
its always desame one on the left