One of the robots I am working on is a fully 3D printed open source robot that I will share online with all the code, STL files, a list of parts and instructions on how to assemble. At first I wasn't planning on using an EZ-B for this, because I didn't think of it, but it is the perfect controller for this project.
By cubco
Other robots from Synthiam community
Justinratliff's Jd Backpack
JD backpack mockup anchors into JD's middle slot with male clip, two top posts, dual rear mounts, wire access and switch...
Ezang's Richard The Robot For Exsophere 4/19/2020 Exciting...
Richard the robot for Exosphere sparks excitement for everyone involved.
Cardboardhacker's Rc Car Ez-Fied
Modify RC truck to run dual DC motors with Sabertooth 2x12 and EZ-B V3, using gearboxes and standard servo steering...
