I am working on a lawn bot made from a power wheelchair. I have been stuck on a controller... the product will part robot part green thumb... I have a layout that will allow it to tow a trailer push a electronic snow thrower /reelmower as well as hold a gas lawn mower... the only thing that would hold me from useing the controler for ez robot is my not uses 24-40 volts for most things...
PS I have local makerspace behind this project as well...
V
By V692
Discover more robots
Justinratliff's Jd Backpack
JD backpack mockup anchors into JD's middle slot with male clip, two top posts, dual rear mounts, wire access and switch...
Ezang's For Some Fun, Arduino LCD Monitor And ARC Serial...
Test Arduino LCD and Synthiam ARC serial monitor 2021 EzAng
Elvisexmachina's 3D Printer Quadruped
Designing and 3D printing an 8-servo quadruped base, testing printed parts and preparing to add sensors and camera after...
