Asked
— Edited
i connected a second ezbv4 on connection 2.i connected 1 rgb and set , the settings to board 2.only the rgb says not connected to ezbv4. what am i missing?
Wowwee MIP V2
— UART interface to hack WowWee MIP with ESP32/ESP32‑Cam or EZ‑B v4 for ARC; hardware UART preferred, configurable power and baud 9600/115200
Try it →
here is a pic from the error.the rgb shows normal blue leds.
funny when i pres the ? mark.i come on the page for auto position.
I’ll take a look and fix it for next release
it seems a bad rgb.i try a new cable no luck there.i tested al 3 12c port with , another rgb.they works.
@Nomad6R, did you figure this problem out?
no .dj wil look into it.problably a faulty rgb.
here is some more info and video.