Irobot Roomba Legacy icon Irobot Roomba Legacy — Legacy iRobot Discovery and 4xxx control via EZB software-serial (D0), supports Arduino/EZ-Robot, adjustable baud rate; not for hardware UART/USB Try it →
USA
Asked — Edited

H-Bridge

Skip to comments Jump to end

Hello,

I a previous reply regarding motors I was told that I needed to use an H-Bridge. Is it ok to use something like a Texas Instruments L293NE or SN75446 or some other type of IC instead of the more complex type of H-Bridge setups that I have seen? I am very new to this and am looking for the simplest method possible.

Any help is very much appreciated.

soky157

Jump to end

ARC Pro

Upgrade to ARC Pro

ARC Pro is more than a tool; it's a creative playground for robot enthusiasts, where you can turn your wildest ideas into reality.

Author Avatar
PRO
Synthiam
LinkedIn Thingiverse Twitter YouTube GitHub
#1  

I guess if you want to make your own. But those are way more complicated.

Wait a few more days until we release our new motor controller

Login to post a comment