I wouldn't know the answer to that. But if Jeremie sees this, he can let you know. Your best bet is to reach out to their Contact Us on their website. That sounds super cool about the new base! I don't see why they would have a problem with it. It is not their original design, so it is built off an open-source project. I imagine your contribution to the project would be appreciated by them. Either way, you can post the design here to share!

hi dj

i did used there Contact Us page . the base is almost finisch for testing . here's a picture how it looks sofar . its 7.5 cm high .  a little video of the old base i used to make the new one . a servoblock goes in front and locked underneed with two lockers . https://www.youtube.com/shorts/1gRdVR_xo1A

it has the yes motion and the sideways motion .same as the full inmoove .

thanks

hi all

the base went perfect . servo's fits like a glove . printing the short pistons . the servo are original HDD ez robot .and no taking out the pot . the motion is just enought to see it 1 to 180 degree . when all is tested i will post the folder here .

https://www.youtube.com/shorts/vMkCdX3W6go

When you’re finished Nomad I would love a copy of your STL’s :-).

hi nink

i will post the folder here when all parts are tested . i have one to do for the side servo's . i'm making a drive shaft for the side servo's cause they dont line up . here you can see the diff the gear doesn line up . its about 10 mm diff .

i hope this help .a drive shaft just like a car .

thanks for your interest .

Great progress, thanks Nomad. I am looking forward to see the finished product.

hi nink

did some tinkering with the moveble wormgear .

this is how the bottem looks.

here is how the moveble wormgear looks like .

https://www.youtube.com/shorts/rxLAR_-D-u4

Nice work @Nomad,

No we aren't on Holiday but we do have some staff that are away sick and Dennis is travelling. Our apologies for not getting back to you.

Great work! Looks like you're having fun with the remixing, keep it going! Thanks for posting a video too, I look forward to more!

hey jeremie

ah that explains averything . my appolegies for being impatients .  a few more test and the base will be reddy .:D

hi all

some update on the new inmoove base . i added an extra hole to be able to use a second eye camera . you could connect a second iotiny or ezbv4 and place it on  the backside of the base .alot more connections . the cable goes from the eye thru the neck al the way down and out in the back .