There have been some people noticing that we have had lots of plastic injection molded parts arriving at our office. As we are ramping up for shipping to customers, we are slowly verifying the final changes and creating jigs to make our assembly workers happy and efficient.
I grabbed a few of the parts to take photos for you. Can you guess which parts are for what?
I grabbed a few of the parts to take photos for you. Can you guess which parts are for what?
I wont spoil it for everyone else and answer most of those
Let's have some fun seeing who else has eyes as keen as mine are
No offence, but those look way better then the 3d prints... Obviously, right?.... They look awesome DJ, can't wait to get my other orders...
Cheers
what are the part number 4-15-16 i never seen these.
Most I got, except for #15... Not sure where that goes
number 8 is also new to me.
1 housing ez-4 2right foot 3 radar sonar 4 batt cover rolli 5 body six 6 left gripper 7 camera housing 8 goes on number 18 9 goes on 5 10ez-b4 11 leg six 12 rgb array 13 heavy duty servo arm 14 cup holder 15 ? 16 batt cover rolli 17 choulder servo 18 gripper servo 15 looks some got to do whit the camera.
#15 - Roli's back hatch/wire pass.
I'll be honest, I didn't realize what 15 and 16 were until others mentioned them but once they did my memory was refreshed. Especially #16. Once I saw the posts about it I felt dumb for not recognizing that one. @DJ- Awesome looking parts. I'm very excited to see these. Thanks for the update.
yep indeed
i didn knew that.but what is 8?
I'm going to let you continue guessing at #8
who me hahaha
first gess,is it a female horn?
Sorry nomad but, yes, 8 (as it's currently being used) is the female horn that attaches to the servos inside JD's body that the arms clip onto. Those are the servos that provide the up/down/vertical motion.
i never would gess it.offcourse.choulder chest.is it useble for this servo too?
is part number 8 separt to by here in shop?
#8 is simple. Its that lost piece that you need in order to complete your robot. Without it, nothing works. Seems like there is always one of those...
hi cochran i think two,each choulder. i need 4,
@d.cochran it goes along with that single really long screw that you have left over once it's built.
does the back side off #8 fit over the axel off the servo? are these for sale?
You can 3D print #8. Here is the link: https://synthiam.com/Community/Revolution/EZBitDetails.aspx?guid=f75cd415-f7d0-4290-ae97-979c6c03c869
Yes #8 slides over the axel/spline of the servo.
Is there any plans to sell the parts by them self's on the site to use that cant print them I would like to be able to get some parts that are not listed for sale
same here no printer.and i need two #8. any one is willing to print them for me?
thank you
There are plenty of online print services available worldwide if nobody here can help you out.
ah ok,thank you rich
i cant save the stl i make cause i dont have a printer and dont know howlong it takes to print it. the bit builder as k the estimated time before i can save.so i need someone who can save it, for me.
dj thanks for the link,here's a pic where i will use part#8 for.
the video chows similar what jd will be able to do.hole the way from 0 to 180 degrees.