Asked
— Edited
Hey DJ,
I was just wondering what you are using on the ez-b to get 3.3v
i saw this tutorial but i'm not sure if it will work.
SSC-32 Servo Controller V2
— Bridge ARC to Lynxmotion SSC-32: maps V0-V31 to SSC-32 channels for reliable, high-performance serial control via USB, EZB/Arduino UART.
Try it →
That link doesn't respond. There are 5v and 3.3v on the ez-b.
there are 2 5 volt supplies. one is for the i/o, the other is for the micro and bluetooth module. they are seperate so the chip doesn't brown out from the i/o
the 3.3 is created by that little VR on the side by the little power plane. i forget what 3.3 VR is being used hahaha
could it be this one:
click?
This one: https://search.digikey.com/scripts/DkSearch/dksus.dll?WT.z_header=search_go&lang=en&site=us&keywords=+L4931CZ33-AP&x=0&y=0