dave_hall
United Kingdom
Asked
— Edited
HI all ive got the 2.5A H bridge and have gone through a whole load of tutorials but one thing im not to sure on as i cant find anything on this is the voltage into the vcc. I want to use 24v as thats what my motors are using but because im using 7volts on the ez b v4 i want to use the switch for the 5v feed and not have a feed from ez b to the 5v+. Is 24v going to fire the h bridge if im using 24v or is the voltage reg on the board good for that voltage. Sorry if its a silly question just dont want to fry anything.
thanks
EZB4/ioTiny specs... EZB4 specs FYI the ezb4 and ioTiny do not have an on board 5v regulator ... power in = power out on the power pin (red pin)
We are talking about the H bridge motor driver board not the output from the ez b, I know that puts out what u put in. But I'm trying to find out if it's OK for 24v in the vcc and if that power source can also run this 5v feed via the on board regulator or if I need to run its own feed to that block.
In your last post you weren't clear on which one you were talking about...