Cameron
Country: USA
Member Since:
Achievements
-
2016-02-08 - connected ARC to the cloud
-
2016-05-02 - created first new question
-
2017-03-15 - shared your first photo in the forum
Latest submissions
Questions (7)
Robots (1)
Skills (0)
General (0)
Hack Events (0)
Tutorials (0)
Apps (0)
Firmwares (0)
3D Parts (0)
Feature Requests (0)
question
H Bridge
Hey everyone, I have been trying to get my H bridge to move both of my 12 Volt DC motors. They moved a little bit at one point with the control movement panel and a script and when I test them directly to...
9
2 k
Nomad 6R |
question
Ssc-32U Servo Controller Script
Hey Everyone, I cant seem to figure out why my Servo Controller isnt working. I have put in the start up and opened up the control in ARC and it still doesnt seem to work. I have power to it from a port on EZB (D18 UART 2) and have it connected to a battery source. (I even tried it to UART 0) I have tried Baud Rate 38400 and 115200 and it seems to...
15
3 k
Cameron |
question
Sound Sensors
Hey Everyone! I am currently stuck on how to code these 2 sound sensors (1 on left, 1 on the right)(picture below) on the head of my robot. I have a servo (D18) that goes up to 180 degrees and I...
40
5 k
Cameron |
question
Ssc-32U Servo Controller
Hey Everyone, I am currently trying to figure out how I will connect this servo controller to the Ezb V4; I am stuck on which cable to use as well. I also wondering about...
4
3 k
PhG |
question
Dc Motors And H-Bridges
Hey everyone! I wanted to ask for help with some dc motor assistance. I currently have 2 12v DC Motors with an L298 H bridge I will attach both of them in pictures. The issue...
8
2 k
Cameron |
question
Ezb V4 Red Light Flashing And Saying Left
Hello Everyone, my Ezb v4 recently has been flashing red while connected to ARC and saying LEFT. I have tried disconnecting and connecting again a few times, it stops then comes back. Still runs scripts just fine, but not sure what im missing. Any help is appreciated Thanks
5
2 k
kamaroman68 |
question
Ezb-V4
Hello, I have an EZB-V4 Wifi Robot Controller that I have not set up yet and every time I go through the wifi settings and try to save new settings it tells me: Cycle power to initialize new settings How would I cycle the power? I cannot seem to find an answer through any other forum on EZ Robot.com I know there must be something small most likely...
2
2 k
Cameron |
No general conversations. Click here to start a conversation.
No robot skills. Click here to view the Robot Skill Store.
No live robot hacking sessions. Click here to view the past live robot hacks.
No user tutorials. Click here to view all user tutorials.
No robot apps. Click here to view all user robot apps.
No firmwares. Click here to view robot hardware and firmwares.
No 3D printable parts. Click here to view 3D printing robot library.
No features requests.