Make an EZ-Builder Behavior Control

Code: Move Servos

If you wish to move a servo, it can be done one of two ways. You can specify the servo to move directly, or take advantage of EZ-Builder's built in servo helpers.

The servo helpers are what you find throughout the EZ-Builder interface, when prompting users to select a servo in configuration screens. The user can always select one or more servos that have a relationship to each other, including inverting. It also allows the user to specify a MIN and MAX for each servo.

User-inserted image


The servo Helper in EZ-Builder makes moving servos a breeze - and that will make your plugin interact with servos much easier, without having to perform all the relationship math and limits yourself.

Servo Movements (Raw)
To move a servo with raw commands, not using the servo helper, here is path to the class:

EZ_Builder.EZBManager.EZBs[0].Servo

It is non recommended to set servo positions using this method, unless they are non user-configurable servos. If your plugin expects users to configure the servos, use the UCServoSelection object and the helper methods below.

Servo Movements (UCServoSelection)
The EZ-Builder UI has the ability for users to specify multiple servos and have the positions relative to each other with invert options, etc This can be viewed in the sourcecode for the Click servo plugin here: https://synthiam.com/Software/Manual/16147

You can install that plugin to see how it works, and watch the video on how to set it up. The example in that source code demonstrates how to use the UCServoSelection user control for users to specify multiple servos, if you choose to go this route. You will notice that the array collection of servos is passed to helper commands in the EZ_Builder.EZBManager directly.

By using the UCServoSelection and EZ-Builder.EZBManager helper methods, the servo configuration can be easily stored in the project file and passed to helper methods for executing. For example, to extract and store the user's servo configuration from a UCServoSelection into the project file can be like so...

Code:


_cf.SERVOS.AddOrUpdate(ConfigurationDictionary._HORIZONTAL_SERVOS, ucServoSelectionX.Config);

_cf.SERVOS.AddOrUpdate(ConfigurationDictionary._VERTICAL_SERVOS, ucServoSelectionY.Config);


Now to move the servos from the configuration _cf.SERVOS file, simply do the following...

Code:


EZ_Builder.EZBManager.SetServoIncrement(_cf.SERVOS[ConfigurationDictionary._HORIZONTAL_SERVOS], -1);

EZ_Builder.EZBManager.SetServoIncrement(_cf.SERVOS[ConfigurationDictionary._VERTICAL_SERVOS], 1);

United Kingdom
#5  
Trying to follow the tutorials but can't find where the plugin page has gone. How do I add a new plugin to the ez-robot / Synthiam site to get the XML?
United Kingdom
#6  
Never mind. Just found the "Create Behaviour Control" link:)
#7  
I am trying to follow the instructions for adding my own plugin but I cannot seem to find the place to register the plugin based on the instructions.

Any help is appreciated.

Thanks
Synthiam
#8   — Edited
The new button to create a plugin behavior control is less than an inch below the button you pressed to create this question. :)

User-inserted image
#9  
Thanks for the quick response.

This what happens when you are working on robotics when its way past your bed time.

You miss the obvious