Robojack

Control Command Scriptstartwait In BLOCKLY Prevents The Script From Stopping.

Im using BLOCKLY to Control Command ScriptStartWait a certain script.  It appears that once the called for script starts it cannot shut down properly.  This only happens when using Control Command ScriptStartWait.  All other times the called for script starts and runs as expected.  This is a new phenomenon and does not occur with a previous version...

Assistance With Slow Scripts

I am running 7 scripts at once.  Each is looping and looking for a variable that is generated by other scripts.  Once these variables are triggered,  each script runs a series of commands and returns back to looping. Some of my scripts have nested loops operating inside of other loops and break out as necessary. I am using FOREVER LOOPS because...

Timer Script Help

Hi Everyone, Ive searched for several hours now for a solution to my problem, all to no avail. I need to start an internal timer during the normal running of a script. The timer will be started with a variable going TRUE or a servo position reached. It will be stopped in the same manner. It cannot be a typical COUNT function but must be actual...

Control Command, Resume

I am having difficulty with Command Control Resume. Can someone please provide an example in blockly how it could be used? I seem to be using START, STOP, WAIT correctly but if you have any additional info on these also I would very much appreciate it. Thanks!

4-1 Sensor Noise

Hi Everyone, I am attempting to use the 4-1 Sensor in my Roli project. The 4-1 like all similar sensors I am familiar with outputs a lot of noise. I am using a script that gets multiple samples and then averages the results. This cuts down the erratic nature of the data but degrades the ability to sense a deviation in the process. Any help here?...

Hbridge

I have a Roli HBridge that has stopped working Forward on the Right Tread only. I have checked all wiring on EZB4 and the Hbridge. After a short run(3-4) seconds in Forward the Heat Sinked IC becomes very hot, enough to burn the skin. The Hbridge intermittently cuts in and out during this time. Any suggestions? Thankyou

H Bridge Pwm Movement Control

This question is about the HBridge PWM Movement Control on the most recent version of ARC software. I have a Roli and have determined that the FWD AFT LEFT RIGHT Arrows function as they should but the Speed Sliders do not. Specifically the Speed Sliders operate the opposite track. When the LEFT slider is moved the Right Track speed changes. When...