Behavior Control
Help Index

WowWee MIP Movement Panel

How To Add This Control To Your Project

  1. Load the most recent release of EZ-Builder
  2. Press the Project tab from the top menu bar of EZ-Builder
  3. Press Add Control from the button ribbon bar of EZ-Builder
  4. Choose the Third Party Robots category tab
  5. Press the WowWee MIP Movement Panel icon to add the control to your project
The WowWee MIP robot is hackable with a UART port on the main board. Connect the GND, TX and RX to the EZ-B's UART Port 0 TX and RX to control it from the EZ-B v4.

We found that the batteries in the WoWwee were not strong enough to power the EZ-B v4 & camera at the same time, so we connected an additional 9volt battery to power the EZ-B v4.

*Note: Remember that if you are powering the EZ-B v4 off a seperate power source, you will need to connect the GND together. It doesn't matter where the GND's come from, long as they are shared between the MIP and EZ-B v4.
Note: EZ-Robot is not a manufacturer of this third party hardware device. . Nor is ezrobot responsible for the operation of this third party device. For operational questions, it's best to consult the instruction manual for operational instructions.