Behavior Control
Created
Updated
Index

Kondo KRS ICS Servos

Control Thumbnail

How To Download and Use This Control

  1. Make sure you have the latest version of EZ-Builder installed.
  2. Select the Install button below to download the file.
  3. Double click the downloaded file to open installer.
  4. The installer will add this control to EZ-Builder.

*Note: This is experimental

I cannot verify this works because I do not have hardware to test with. This plugin is in response to a community thread regarding Kondo servos.

This plugin uses a DLL found in the configuration utility installation folder. The servos can be chained together and connected to the EZ-B's UART #1 on port D5. The baud rate must also be configured in the settings of the plugin. Each virtual port can be selected for the communication version based on the servo model. The Max Positions are unknown values to me when creating the plugin. Much experimenting from the user is required.

User-inserted image


Supports:
- Release()
- Servo() and all controls using servos via Virtual servo Ports

Not Supported (yet):
- ServoSpeed()