Behavior Control
Help Index

Comm Expansion Configuration

How To Add This Control To Your Project

  1. Load the most recent release of EZ-Builder
  2. Press the Project tab from the top menu bar of EZ-Builder
  3. Press Add Control from the button ribbon bar of EZ-Builder
  4. Choose the General category tab
  5. Press the Comm Expansion Configuration icon to add the control to your project
The Comm Expansion Configuration is an add-on to the EZ-B v4.x/2, which can be configured for two modes. This control is an utility which is used to configure the Comm Expansion module.

UART Mode

Enables the Comm Expansion UART mode, which allows transparent proxy of UART data between the PC and Comm Expansion module's UART.

USB Mode

Connect a USB cable from the Comm Expansion adapter to the PC for direct USB communication rather than WiFi. This benefits robots with onboard computers to not be limited to using WiFi communication. The EZ-B is not provided power from USB and will require seperate power.